What Is A Cigarette Case?

A cigarette case tends to be a sturdy container used to store small amounts of cigarettes. It even prevents these from being crushed. But, when it comes to a typical cigarette case is a flat box that opens symmetrically, particularly into two halves. Every half store, a row of cigarettes is usually held in place with the aid of a spring or even an elastic strap. It is possible to get custom cigarette boxes and cigarette boxes wholesale. You can even make a cigarette box by yourself. To find out how to continue reading on.

Why Make A Cigarette Case

Making your own cigarette box to keep your cigarettes may be accomplished within 30 minutes, with felt and moderate sewing machine skills. Due to the fiber content, particularly felt, no hemming tends to be needed, and you can get a charming edge using pinking shears before starting sewing the cigarette case. You should know that a simple felt case tends to be practical as well as inexpensive to make. You can get custom cigarette boxes and cigarette boxes wholesale.

Read on to learn more.

Making The Shape Of The Cigarette Box

You must trim all felt edges using a pair of good pinking shears. Then, put a side rectangle precisely on top of your front rectangle while aligning the right 4-inch type of long edges. You can then pin. Put a side rectangle specifically on top of your back rectangle while aligning the left 4-inch type of long edges. You can then pin.

Sewing The Cigarette Case

After this, sew the front/side using a vertical seam along the edge, employing a straight stitch plus a ¼-inch seam allowance, particularly on the machine. Next, you can sew the backside with a vertical seam along the edge utilizing a straight stitch and a ¼-inch seam allowance. You can then remove the pins. After this, flatten the front/side with the “inside” area of the case. You should know that the pinked edges/seams are outside your cigarette case. Next, put the bottom rectangle on top of your front rectangle. You should align the 3-inch type of wide edges. First, pin and sew horizontally across the bottom or front edge, utilizing a straight stitch and a ¼-inch seam allowance. Now remove the pins.

Now place the inside together, specifically the front or right side and the back/left side. Your completed case must have the pinked edges visible. Now you should be viewing the outside of your cigarette case. Next, align the left 4-inch long edge plus the 4-inch long edge, specifically on the left side (it should be connected to your case’s back. Pin and then sew employing a straight stitch plus ¼-inch seam allowance. Then remove pins. When this is done, align the 4-inch type of long edge, particularly on the back, with the 4-inch long edge of the right side (i.e., attached to the front). Then pin and sew using a straight stitch, with a ¼-inch seam allowance. Then remove pins.

Standing The Case Up

The fingers should be used to stand your box erect. Next, you need to bring the bottom rectangle specifically into place underneath. Then pin the two sides moreover back along the bottom edges. Finally, sew employing a straight stitch plus a ¼-inch seam allowance. The case should now be the shape of an exciting cigarette box.  Then align one 3-inch type of long flap end with the top edge of your back case area. Position the flap about ½-inch from the edge, then pin and sew across the flap or back horizontally, utilizing a straight stitch. Remove the pins.

You can hand sew only one area on the snap ½-inches, particularly from the top center type of edge of your front area of the case. Sew the other snap area ½-inch from your front flap edge. This is on the underside.